LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1121 (Engine - 4.6L And 5.4L) >> In-Vehicle Servicing >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the new O-ring seal with clean engine oil.
  1. Clean and inspect the mating surfaces and install a new O-ring seal.
  2. Install the oil pump and loosely install the 3 bolts.
    • Tighten the bolts in the sequence shown.
    • Tighten to 10 Nm (89 lb-in).
    3. Fig 1: Identifying Oil Pump Bolts Tightening Sequence
    G03962526Courtesy of FORD MOTOR CO.
  3. Install the crankshaft sprocket. For additional information, refer to Timing Drive Components - Windsor Engine (5.4L)  or Timing Drive Components - Romeo Engine (4.6L) .
  4. Install the oil pan. For additional information, refer to Oil Pan .
scientia non olet · About LEMON Manuals