LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1121 (Engine - 4.6L And 5.4L) >> In-Vehicle Servicing >> Oil Level Indicator and Tube >> Installation

Oil Level Indicator and Tube: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

4.6L (2V) engine 

    NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
  1. Using a new O-ring seal, position the oil level indicator and install the bolt and the nut.
    • Tighten to 10 Nm (89 lb-in).

    2. 5.4L (2V) engine 

    NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
  2. Using a new O-ring seal, position the oil level indicator and install the bolt.
    • Tighten to 10 Nm (89 lb-in).
  3. Install the front oil level indicator and tube support bracket nut.
    • Tighten to 25 Nm (18 lb-ft).

    4. All vehicles 

  4. Install the LH exhaust manifold. For additional information, refer to Exhaust Manifold - LH .
  5. Install the ACL outlet pipe and the ACL. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
scientia non olet · About LEMON Manuals