Disabling Unlimited Key Mode

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: By disabling the unlimited key mode, the previous access code no longer operates the vehicle.

From the scan tool, enter TOOLBOX. Select BODY-SECURITY-PATS Functions and follow the on-screen instructions to ENTER SECURITY ACCESS. This procedure takes approximately 10 minutes to carry out, during which time the ignition key must be in the ON position and the scan tool must be connected to the vehicle. For additional information, refer to Anti-Theft Security Access .
Select: "unlimited key mode OFF" and press the tick mark.
Select: "Ignition Key Code Erase" and press the tick mark.
Disconnect the scan tool and turn the ignition switch to the OFF position (the key does not need to be removed at this time).
Turn the first PATS key in the ignition lock cylinder to the ON position for 3 seconds.
Turn the first PATS key to the OFF position and remove the key from the ignition lock cylinder.
Insert the second PATS key into the ignition lock cylinder and turn the key to the ON position for 3 seconds.

NOTE: With the unlimited key mode turned off, a maximum of 8 keys can be programmed into the IC using the Key Programming Using Two Programmed Keys . The IC SPAREKEY PID must be enabled.

If it is desired to program additional key(s), refer to Key Programming Using Two Programmed Keys for each additional key (up to 8 keys, total) that needs to be programmed. The IC SPAREKEY PID must be enabled.