LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1111 (Anti-Theft - Passive Anti-Theft System (Pats)) >> Diagnostic Tests >> Anti-Theft >> Pinpoint Tests >> Pinpoint Test H: The Vehicle Does Not Start >> Pinpoint Test H: The Vehicle Does Not Start

Pinpoint Test H: The Vehicle Does Not Start

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. H1 CHECK FOR COMMUNICATION WITH THE PCM AND INSTRUMENT CLUSTER (IC) 
    • Connect the diagnostic tool.
    • Key in ON position.
    • Carry out the network test using the scan tool.
    • Does the scan tool establish communication with the PCM and the IC? 
    1. YES  : Go to  H2.
    2. NO  : REFER to MODULE COMMUNICATIONS NETWORK article to diagnose the module that is not communicating with the scan tool.
  2. H2 CHECK FOR INSTRUMENT CLUSTER (IC) DTCs 
    • Retrieve the IC continuous and on-demand DTCs.
    • Are any IC DTCs present? 
    1. YES  : REFER to DTC Charts .
    2. NO  : The no-start condition is not PATS-related. REFER to the appropriate Engine Performance article to diagnose the cause of the no-start condition.
scientia non olet · About LEMON Manuals