LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Instrument Cluster (Ic), Message Center, And Warning Chimes) >> Removal And Installation >> Instrument Cluster (IC) >> Removal

Instrument Cluster (IC): Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. If installing a new instrument cluster (IC), upload the module configuration information to the scan tool using the programmable module installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION article.
  2. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  3. Remove the instrument cluster (IC) finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  4. Remove the 4 screws and position the instrument cluster (IC) away from the instrument panel.
    • Disconnect the electrical connectors.
  5. Disconnect the transmission range indicator and remove the instrument cluster (IC).
scientia non olet · About LEMON Manuals