LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Instrument Cluster (Ic), Message Center, And Warning Chimes) >> Removal And Installation >> Instrument Cluster (IC) >> Installation

Instrument Cluster (IC): Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the instrument cluster (IC) in the instrument panel and connect the transmission range indicator.
  2. Connect the electrical connector and install the 4 instrument cluster (IC) screws.
  3. Install the instrument cluster (IC) finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  4. Connect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  5. If installing a new instrument cluster (IC), download the instrument cluster (IC) configuration information from the scan tool into the new instrument cluster (IC). For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION article.
  6. NOTE: If a new instrument cluster (IC) is installed, the instrument cluster (IC) and the powertrain control module (PCM) require a parameter reset to allow the instrument cluster (IC) and the PCM to recognize each other. Failure to carry out the parameter reset to the instrument cluster (IC) and the PCM may result in a no start condition on both passive anti-theft system (PATS) and non-PATS vehicles.
  7. If installing a new instrument cluster (IC), carry out the parameter reset procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
  8. If installing a new instrument cluster (IC), carry out the key programming. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.