LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1104 (Supplemental Inflatable Restraint System) >> General Procedures >> Supplemental Restraint System (SRS) Deactivation and Reactivation >> Reactivation Procedure

Reactivation Procedure

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RCM fuse 20 (10A) from the CJB.
  2. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  3. Connect the passenger air bag module electrical connector.
    4. Fig 1: Locating Passenger Air Bag Module Electrical Connector
    G03891336Courtesy of FORD MOTOR CO.
  4. Position the RH lower instrument panel finish panel reinforcement. Install the bolts.
    5. Fig 2: Locating RH Lower Instrument Panel Reinforcement Retainer Bolts
    G03890087Courtesy of FORD MOTOR CO.
  5. Align the retaining clips and install the RH lower instrument finish panel.
    6. Fig 3: Locating RH Lower Instrument Finish Panel
    G03890086Courtesy of FORD MOTOR CO.
  6. Install the driver air bag module.
    1. Connect the horn electrical connector.
    2. Connect the driver air bag module electrical connector.
    3. Position the driver air bag module into the steering wheel.
    4. Install the 2 driver air bag module bolts (1 shown).
      • Tighten to 6 Nm (53 lb-in).
    5. Install the 2 driver air bag module bolt caps (1 shown).
    7. Fig 4: Installing Driver Air Bag Module
    GF0011555Courtesy of FORD MOTOR CO.
  7. Turn the ignition switch from OFF to ON.
  8. Install the RCM fuse 20 (10A) and install the cover.
    9. WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
  9. Connect the battery ground cable.
  10. Prove out the SRS as follows:

    Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag warning indicator with the air bag modules installed. The air bag warning indicator will light continuously for approximately 6 seconds and then turn off. If an air bag SRS fault is present, the air bag warning indicator will:

    - fail to light.

    - remain lit continuously.

    - flash.

    The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag warning indicator and any SRS fault discovered must be diagnosed and repaired.

    Clear all continuous DTCs from the RCM using a scan tool.

scientia non olet · About LEMON Manuals