Seat Armrest - Front

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: LH shown, RH similar.

NOTE: Install a new crown washer when re-installing the armrest.

Remove the armrest.
1. Release the hook-and-loop at the rear of the armrest trim cover and access the armrest bolt.
2. Remove the armrest bolt and crown washer.
  - To install, tighten to 35 Nm (26 lb-ft).
3. Remove the armrest.

Fig 1: Armrest Trim Cover & Bolt

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.