Pinpoint Test R: The Trailer Lamps Are Inoperative - All
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
- R1 CHECK CIRCUIT 206 (WH) FOR AN OPEN
- Disconnect the trailer from the vehicle.
- For the 4-pin connector, measure the resistance between the trailer tow C4098-1 206 (WH), harness side and ground.
- For the 7-pin connector, measure the resistance between the trailer tow C4099-2, circuit 206 (WH), harness side and ground.
- Is the resistance less than 5 ohms?
- YES : Go to R2.
- NO : REPAIR the circuit. TEST the system for normal operation.
- R2 CHECK CIRCUIT 57 (BK) FOR AN OPEN (ALL LAMPS INOPERATIVE)
- Disconnect: Trailer Tow Parking Lamp Relay
- Measure the resistance between the trailer tow parking lamp relay pin 2, circuit 57 (BK), BJB face side and ground.
- Is the resistance less than 5 ohms?
- YES : The vehicle is operating correctly. SEND the trailer to an authorized camper/trailer repair facility.
- NO : REPAIR the circuit. TEST the system for normal operation.