Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Install the Engine Support Bar.

Fig 1: Supporting Engine With Special Tool

Courtesy of FORD MOTOR CO.

Remove the engine mount bracket bolt.
- To install, tighten to 115 Nm (85 lb-ft).
Use the Engine Support Bar to raise the engine 25 mm (0.98 in).

Fig 2: Supporting Engine With Special Tool

Courtesy of FORD MOTOR CO.

Remove the 3 nuts and the engine mount bracket.
- To install, tighten to 115 Nm (85 lb-ft).
Remove the 3 bolts and the engine mount.
- To install, tighten to 55 Nm (41 lb-ft).
To install, reverse the removal procedure.