LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1020 (Information Center) >> Removal And Installation >> Instrument Cluster (IC) >> Removal

Instrument Cluster (IC): Removal

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. If installing a new instrument cluster (IC), upload the module configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION article.
  2. Lower the tilt steering column to the lowest position.
  3. Pull the instrument cluster (IC) finish panel straight out to release the retainer clips and remove the finish panel.
    • Disconnect the instrument panel dimmer switch electrical connector and the ambient air temperature sensor (if equipped).
  4. Remove the 4 instrument cluster (IC) screws and the instrument cluster (IC).
    • Disconnect the electrical connector.
scientia non olet · About LEMON Manuals