LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1000 (Wiper System And Washer System) >> Removal And Installation >> Wiper Motor - Rear Window >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear pivot arm. For additional information, refer to Wiper Pivot Arm - Rear .
  2. Remove the rear wiper motor shaft nut cover.
  3. Remove the rear wiper motor shaft nut.
    • To install, manually finger-tighten the nut, then tighten to 6 N.m (53 lb-in).
  4. Open the liftgate window.
  5. Remove the rear wiper motor cover trim panel.
    6. Fig 1: Identifying Rear Wiper Motor Cover Trim Panel
    GF0041909Courtesy of FORD MOTOR CO.
  6. Remove the rear wiper motor.
    1. Disconnect the electrical connector.
    2. Remove the 2 rear window wiper motor nuts.
      • To install, tighten to 7 N.m (62 lb-in).
    3. Remove the rear window wiper motor.
    7. Fig 2: Identifying Connector, Nuts And Rear Window Wiper Motor
    GF0041910Courtesy of FORD MOTOR CO.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals