DTC P1703: Brake Switch Out Of Self-Test Range

P1703 - BRAKE SWITCH OUT OF SELF-TEST RANGE

Description:	Indicates that during key on engine off (KOEO) self-test, the brake pedal position (BPP) signal was high, or during key on engine running (KOER) self-test, the BPP signal did not cycle high and low.
Possible Causes:	Open or short in the BPP circuit Open or short in the stoplamp circuits Concern in module(s) connected to the BPP circuit Damaged brake switch Misadjusted brake switch
Diagnostic Aids:	Check for correct function of the stoplamps. Using the diagnostic tool, check the BPP PID. The stoplamps and PID should toggle on and off with brake pedal activation.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
Freestar/Monterey, 2006 Town Car	Verify the brake pedal was applied and released during the KOER self-test. For additional concerns, refer to the appropriate EXTERIOR LIGHTING article .
Expedition, Navigator	Verify the brake pedal was applied and released during the KOER self-test. For additional concerns, refer to the appropriate VEHICLE DYNAMIC SYSTEMS article .
All others	GO to Pinpoint Test FD .