DTC P1124: Throttle Position Sensor A Out Of Self-Test Range

P1124 - THROTTLE POSITION SENSOR A OUT OF SELF-TEST RANGE

Description:	The throttle position (TP) sensor circuit is monitored by the powertrain control module (PCM) for an out of range TP rotation angle or voltage input. The test fails if the TP rotation angle or voltage reading is less than 13.27% (0.66 volt) or greater than 23.52% (1.17 volts).
Possible Causes:	Binding or bent throttle linkage TP sensor not seated properly Throttle plate below closed throttle position Throttle plate/screw misadjusted Damaged TP sensor
Diagnostic Aids:	The TP PID reading not between 13.27-23.52% (0.66-1.17 volts) in key ON, engine OFF or key ON, engine running indicates a concern is present.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to Pinpoint Test DH .	GO to Pinpoint Test DH .	-