DTC P0833: Clutch Pedal Switch B Circuit
P0833 - CLUTCH PEDAL SWITCH B CIRCUIT
| Description: | The powertrain control module (PCM) monitors the clutch pedal position top of travel (CPP-TT) switch only during the calibrated engine speed range (cranking speed range). This DTC is set when the CPP-TT does not indicate that the clutch is disengaged (clutch pedal pressed) when the engine is cranked. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Verify that the vehicle was not push-started with the clutch engaged. Check for aftermarket equipment such as remote starting devices which may bypass the clutch pedal position switch when cranking the engine. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the appropriate SPEED CONTROL article . | ||