LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid) >> DTC Diagnosis >> DTC P0350: Ignition Coil Primary/Secondary Circuit

DTC P0350: Ignition Coil Primary/Secondary Circuit

P0350 - IGNITION COIL PRIMARY/SECONDARY CIRCUIT

Description:  Each ignition primary circuit is continuously monitored. The test fails when the powertrain control module (PCM) does not receive a valid ignition diagnostic monitor (IDM) pulse signal from the ignition module (integrated in the PCM).
Possible Causes: 
  • Open or short in the Ignition START/RUN circuit
  • Open coil driver circuit
  • Coil driver circuit shorted to ground
  • Damaged coil
  • Coil driver circuit shorted to VPWR
Diagnostic Aids:  Use the 12-volt non-powered test lamp to verify START/RUN voltage at the ignition coil harness connector.
Check the coil driver circuit for open, short to VPWR, or short to ground.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to Pinpoint Test JE .
scientia non olet · About LEMON Manuals