DTC P0121: Throttle/Pedal Position Sensor A Circuit Range/Performance

P0121 - THROTTLE/PEDAL POSITION SENSOR A CIRCUIT RANGE/PERFORMANCE

For Vehicles With Electronic Throttle Control (ETC)
Description:	The electronic throttle control (ETC) throttle position (TP) sensor 1 circuit was flagged as a concern by the powertrain control module (PCM) indicating an out of range in either the closed or wide open throttle (WOT) modes.
Possible Causes:	Obstruction in the throttle plate movement Damaged throttle body TP circuit open to PCM Damaged TP sensor SIG RTN circuit open to the TP sensor
Diagnostic Aids:	This concern exhibits a symptom of limited power. A TP1 PID (TP V PID) reading less than 13% (0.65 volt), or greater than 93% (4.65 volts) in key ON, engine OFF or key ON, engine running indicates a concern is present.
For All Others
Description:	The throttle position (TP) sensor circuit is monitored by the powertrain control module (PCM) for a non-closed throttle position at idle. If the key on engine running (KOER) self-test terminates upon placing the transmission gear selector in DRIVE or REVERSE or when closing the throttle (idle) after opening it (in PARK or NEUTRAL) the TP closed throttle position is not attained, and the test fails.
Possible Causes:	Binding throttle linkage Damaged throttle body TP circuit open to PCM Damaged TP sensor SIG RTN circuit open to the TP sensor
Diagnostic Aids:	Drive the vehicle, bring it to a stop, and turn the key to the OFF position. Start the vehicle, and run the key on engine running (KOER) self-test at idle.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
Vehicles With Electronic Throttle Control (ETC)	GO to Pinpoint Test DV .
All others	GO to Pinpoint Test DH .