DTC P0107: Manifold Absolute Pressure (Map)/Barometric Pressure (BARO) Sensor Low

P0107 - MANIFOLD ABSOLUTE PRESSURE (MAP)/BAROMETRIC PRESSURE (BARO) SENSOR LOW

Description:	Sensor operating voltage is less than 0.25 volt (VREF). As a result it failed below the minimum allowable calibrated parameter.
Possible Causes:	Open in the circuit, or short to ground VREF circuit open, or short to ground Damaged MAP sensor
Diagnostic Aids:	VREF should be greater than 4.0 volts. The PID reading is in frequency/volts.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to Pinpoint Test DM .