LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls - Pinpoint Test KE: Idle Air Control (IAC) Valve Through Pinpoint Test Z: Intermittent - (Except Diesel & Hybrid) >> Pinpoint Test QE: Electronic Throttle Control (Etc) System >> Introduction

Pinpoint Test QE: Electronic Throttle Control (Etc) System: Introduction

This pinpoint test is intended to diagnose the informational powertrain control module (PCM) DTCs.

The informational DTCs are the result of limited operating strategy (LOS) or failure mode effects management (FMEM) operating strategy that maintains limited vehicle function in the event of a PCM, harness, or component concern.

Circuit DTCs can be accompanied by the informational DTCs, and should be diagnosed first. Informational DTCs without circuit DTCs may or may not indicate the actual concern and should be diagnosed as a symptom.

Fig 1: EGR System Module (ESM) Connector
G04587275Courtesy of FORD MOTOR CO.