LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine >> In-Vehicle Repair >> Engine Oil Pressure (EOP) Switch >> Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY MOUNTING AND CABLES .
  3. Disconnect the electrical connector from the oil pressure sender.
  4. Remove the oil pressure sender.
    • To install, tighten to 15 Nm (11 lb-ft).
    5. NOTE: Apply Thread Sealant with PTFE to the sender threads.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals