LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System-General Information >> General Procedures >> Crankshaft End Play

Crankshaft End Play

SPECIAL TOOL(S)

G04651836Courtesy of FORD MOTOR CO.
 Dial Indicator Gauge with Holding Fixture
100-002 (TOOL-4201-C) or equivalent
  1. Measure the crankshaft end play. Use a Dial Indicator Gauge with Holding Fixture to measure crankshaft end play.
  2. Position the crankshaft to the rear of the cylinder block.
  3. Zero the indicator.
  4. Move the crankshaft to the front of the cylinder block. Note and record the crankshaft end play.
    • If crankshaft end play exceeds specifications, install a new crankshaft thrust washer or crankshaft thrust main bearing. Refer to ENGINE - 2.0L AND 2.3L for the procedure.
      Fig 1: Measuring Crankshaft End Play
      G03885013Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals