LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System-General Information >> General Procedures >> Camshaft End Play - OHC Engines

Camshaft End Play - OHC Engines

SPECIAL TOOL(S)

G04651829Courtesy of FORD MOTOR CO.
 Dial Indicator Gauge with Holding Fixture
100-002 (TOOL-4201-C) or equivalent
  1. Use a Dial Indicator Gauge with Holding Fixture to measure camshaft end play.
  2. Position the camshaft to the rear of the cylinder head.
  3. Zero the indicator.
  4. Move the camshaft to the front of the cylinder head. Note and record the camshaft end play.
    • If camshaft end play exceeds specifications, install new camshaft and recheck end play. Refer to ENGINE - 2.0L AND 2.3L for the procedure.
    • If camshaft end play exceeds specification after camshaft installation, install a new cylinder head. Refer to ENGINE - 2.0L AND 2.3L for the procedure.
      Fig 1: Using Dial Indicator Gauge With Holding Fixture To Measure Camshaft End Play
      G03885002Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals