LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Removal And Installation >> Exhaust Flexible Pipe

Exhaust Flexible Pipe

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
    2. CAUTION: Do not excessively bend or twist the exhaust flexible pipe. Failure to follow these instructions may cause damage to the exhaust flexible pipe.
    Fig 1: Locating Exhaust Flexible Pipe With Support Wrap
    G04653575Courtesy of FORD MOTOR CO.
  2. Support the exhaust flexible pipe with a support wrap or suitable splint.
  3. Remove and discard the 2 exhaust flexible pipe-to-muffler assembly nuts.
    • If necessary, install new studs.
    • To install, tighten to 47 Nm (35 lb-ft).
  4. Remove and discard the 2 exhaust flexible pipe-to-converter nuts and remove the exhaust flexible pipe.
    • If necessary, install new studs.
    • To install, tighten to 47 Nm (35 lb-ft).
  5. To install, reverse the removal procedure.
    • Install new gaskets and nuts.
scientia non olet · About LEMON Manuals