Removal and Installation

Remove the antenna mast from the base.
- Rotate the mast counterclockwise.
  
  Fig 1: Rotating Mast
  Courtesy of FORD MOTOR CO.
Remove the interior lamp.
- Disconnect the interior lamp electrical connectors.
  
  Fig 2: Locating Interior Lamp Electrical Connectors
  Courtesy of FORD MOTOR CO.
Remove the 2 screws and the interior lamp bezel.

Fig 3: Locating Interior Lamp Bezel Screws
Courtesy of FORD MOTOR CO.
If equipped, remove the overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
Remove the antenna cable/base screw and the antenna base.

Fig 4: Locating Antenna Cable/Base Screw And Antenna Base
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.