LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Front Drive HALFSHAFTS >> Removal And Installation >> Outer Constant Velocity (CV) Joint Boot >> Removal

Outer Constant Velocity (CV) Joint Boot: Removal

  1. Remove the inner constant velocity joint boot. For additional information, refer to INNER CONSTANT VELOCITY (CV) JOINT BOOT .
    2. CAUTION: Use a vice with protective jaw covers.
  2. Remove the outer constant velocity joint boot.
    • Remove the boot clamps.
    • Pull the boot inwards over the front drive half shaft.
      Fig 1: Removing Boot Clamps
      G04651580Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals