LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Front Drive HALFSHAFTS >> Removal And Installation >> Intermediate Shaft Bearing >> Removal

Intermediate Shaft Bearing: Removal

  1. Remove the intermediate shaft. For additional information, refer to INTERMEDIATE SHAFT .
  2. Using the special tool, press the intermediate shaft bearing off the intermediate shaft.
    Fig 1: Pressing Intermediate Shaft Bearing Off Intermediate Shaft
    G04651565Courtesy of FORD MOTOR CO.
    3. NOTE: Rotate the bearing puller so the flat side is facing upward. Make sure the inner bearing race is supported while pressing the bearing on.
    Fig 2: Pressing Intermediate Shaft Bearing Onto Intermediate Shaft
    G04651566Courtesy of FORD MOTOR CO.
  3. Using the special tool, press the new intermediate shaft bearing onto the intermediate shaft.
  4. Install the intermediate shaft. For additional information, refer to INTERMEDIATE SHAFT .
scientia non olet · About LEMON Manuals