LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake System >> Removal And Installation >> Rear Brake Caliper Anchor Plate >> Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the park brake cable from the brake caliper.
    1. Pull back the parking brake lever.
    2. Disconnect the cable from the parking brake lever.
    3. Remove the cable conduit retaining clip.
    4. Remove the park brake cable from the brake caliper.
      Fig 1: Removing Park Brake Cable From Brake Caliper
      G04651648Courtesy of FORD MOTOR CO.
    3. CAUTION: Do not allow the brake caliper to hang from the hose or damage to the hose can occur.
  3. Remove the 2 brake caliper guide pin bolts and position the caliper aside.
    • Support the brake caliper with mechanic's wire.
    • To install, tighten to 35 Nm (26 lb-ft).
  4. Remove the brake pads.
  5. Remove the 2 brake caliper anchor plate bolts and the anchor plate.
    • To install, tighten to 55 Nm (41 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals