Removal and Installation
WARNING:
Use of any other than approved DOT 3 brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION:
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
- Disconnect the brake hose fitting.
- To install, tighten to 15 Nm (11 lb-ft).
- Remove the brake pad retaining clip.
- Remove the 2 brake caliper bolts and remove the brake caliper.
- To install, tighten to 28 Nm (21 lb-ft).
- Remove the brake pads from the caliper.
- To install, reverse the removal procedure.
- Bleed the brake system. For additional information, refer to BRAKE SYSTEM-GENERAL INFORMATION .
CAUTION:
Cap the brake hose to prevent fluid loss and dirt contamination.
CAUTION:
Do not pry in the caliper sight hole to retract the pistons, as this can damage the pistons and boots.