Removal and Installation

All vehicles

Remove the front door speaker. For additional information, refer to INFORMATION AND ENTERTAINMENT SYSTEM .
Remove the side impact bolster.
Position the door latch release handle aside.

CAUTION: Do not touch the adhesive surface, as re-bonding will be impaired.

Remove the watershield.

Vehicles with power windows

Remove the retainers and position the one-touch down relay aside.

Fig 1: Locating Position One-Touch Down Relay And Retainers
Courtesy of FORD MOTOR CO.
Connect the window control switch electrical connector.

Fig 2: Locating Window Control Switch Electrical Connector
Courtesy of FORD MOTOR CO.

Vehicles with manual windows

Install the window regulator handle.

All vehicles

Remove the 2 door window glass clamp bolts.
- To install, tighten to 8 Nm (71 lb-in).
Hold the window glass at the top of the opening, lower the regulator and remove the window glass from the regulator.
Remove the window glass.
1. Lift the glass.
2. Tip the glass forward and remove the glass from the front of the door.
  
  Fig 3: Removing Window Glass From Door
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.