Roof Opening Panel Motor: Installation
- If installing a previously used roof opening panel motor, carry out the Erasing Roof Opening Panel Motor Initialization procedure. For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION in this article.
- Install the roof opening panel motor and the 3 bolts.
- Tighten to 3 Nm (27 lb-in).
- If installing a new roof opening panel motor, connect the electrical connector.
- Install the overhead console trim panel.
- If installing a new roof opening panel motor, connect the roof opening panel control switch electrical connector.
- Initialize the roof opening panel motor. For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION in this article.
CAUTION:
This step must be carried out if installing a previously used roof opening panel motor.
NOTE:
This step is not necessary when installing a new roof opening panel motor.