LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Sunroof >> Diagnosis And Testing >> Roof Opening Panel >> Components Tests >> Roof Opening Panel Switch

Roof Opening Panel Switch

  1. Measure the resistance between the following:
    ROOF OPENING PANEL SWITCH RESISTANCE SPECIFICATIONS

    Roof Opening Panel Switch Position Pins Measurement
    Neutral 1 -5 Greater than 10,000 ohms
    Neutral 2-6 Greater than 10,000 ohms
    Neutral 5 -6 Greater than 10,000 ohms
    Neutral 6- 1 Greater than 10,000 ohms
    Fully Up/Close 5 -6 Less than 100 ohms
    Fully Up/Close 5 - 1 Greater than 10,000 ohms
    Fully Up/Close 5 -2 Less than 100 ohms
    Fully Up/Close 2-6 Less than 100 ohms
    Fully Down/Open 2-6 Less than 100 ohms
    Fully Down/Open 2-5 Less than 100 ohms
    Fully Down/Open 5 -6 Less than 100 ohms
    Fully Down/Open 2- 1 Greater than 10,000 ohms
  2. Apply battery voltage to the roof opening panel control switch C9014-1, component side, and ground to the roof opening panel control switch C9014-6, component side. The LED should illuminate.
  3. If all measurements of the roof opening panel control switch are as shown, return to the pinpoint test. Otherwise, install a new roof opening panel control switch.
scientia non olet · About LEMON Manuals