LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Removal And Installation >> Seat Cushion - Front >> Removal and Installation

Removal and Installation

WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
WARNING: Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
WARNING: To reduce the risk of personal injury, do not use any memory saver devices.
CAUTION: It is necessary to rezero the occupant classification sensor (OCS) system when a front passenger seat cushion is disassembled, a new trim cover is installed, or an OCS service kit is installed. A scan tool is used to trigger the active command to carry out rezeroing of the OCS system.
NOTE: The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE: If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the supplemental restraint system (SRS) must be depowered. 
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

    All seats 

  1. Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
  2. Remove the front seat. For additional information, refer to SEAT - FRONT .
    3. CAUTION: Note the position and routing of the wiring harness(es) to aid installation. An incorrectly routed wiring harness may lead to damage to the wires.
    NOTE: Driver seat shown, passenger seat similar.
    Fig 1: Locating Safety Belt Buckle Switch Wiring Harness
    G04654358Courtesy of FORD MOTOR CO.
  3. Detach the safety belt buckle switch wiring harness from the underside of the cushion.

    4. Seats with heat 

  4. From the back of the large connector at the outboard side of the seat, release the tab at the top and remove the heated seat electrical connector insert from the large connector.
  5. Disconnect the cushion-to-backrest heated seat electrical connector.

    6. Passenger seat only 

  6. Disconnect the belt tension sensor (BTS) electrical connector and separate from the cushion frame.
    Fig 2: Locating Belt Tension Sensor Electrical Connector
    G04654359Courtesy of FORD MOTOR CO.
    7. NOTE: The inserts are keyed into position within the large electrical connector housing and the insert positions are not interchangeable.
    Fig 3: Locating Occupant Classification Sensor Electrical Connector
    G04654360Courtesy of FORD MOTOR CO.
  7. From the back of the large connector at the outboard side of the seat, release the tab at the top and remove the occupant classification sensor (OCS) electrical connector inserts from the large connector.

    8. All seats 

    NOTE: Driver seat shown, passenger seat similar.
  8. Remove the 4 bolts and the front seat cushion.
    • To install, tighten to 28 Nm (21 lb-ft).
  9. To install, reverse the removal procedure.
  10. Install the front seat. For additional information, refer to SEAT - FRONT .
  11. Repower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
scientia non olet · About LEMON Manuals