LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Exterior Lighting System >> General Procedures >> Front Fog Lamp Adjustment

Front Fog Lamp Adjustment

    NOTE: Horizontal aim is not required for this vehicle and is not adjustable. Consult your state vehicle inspection center for recommended tolerance ranges for visual aiming.
  1. Before starting the fog lamp assembly adjustment:
    • Check the tire inflation.
    • Make sure there are no other loads in the vehicle other than a half tank of fuel.
    • Make sure the vehicle is on level ground.
    • Make sure the fog lamps and headlamps are clean.
    • Make sure the headlamps are operating and are correctly aimed.
    2. NOTE: The vertical wall screen must be a minimum of 2.4-m (8-ft) wide.
    Fig 1: Identifying Headlamps To Screen Dimension
    G04654151Courtesy of FORD MOTOR CO.
  2. Park the vehicle on a level surface approximately 7.6 m (25 ft) from the vertical wall or screen directly in front of it.
  3. The correct visual aim for the fog lamps is with the top edge of the high-intensity zone 10 cm (4 in) below the horizontal center of the fog lamps.
    Fig 2: Identifying Top Edge Of High-Intensity Zone
    G04654152Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals