LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System >> Removal And Installation >> Clutch and Clutch Field Coil >> Removal

Clutch and Clutch Field Coil: Removal

  1. Remove the A/C compressor. For additional information, refer to AIR CONDITIONING (A/C) COMPRESSOR  in this article.
  2. Remove the A/C clutch disc and hub retaining bolt.
    1. Hold the A/C clutch disc and hub with the special tool.
    2. Remove the bolt.
      Fig 1: Using Special Tool To Hold A/C Disc And Hub Assembly
      G03952015Courtesy of FORD MOTOR CO.
  3. Remove the A/C clutch disc and hub.
    1. Thread an 8 x 1.25 mm bolt into the A/C clutch disc and hub spacer to force it from the compressor shaft.
    2. Lift the A/C clutch disc and hub and the A/C clutch disc and hub spacer from the compressor shaft.
      Fig 2: Lifting A/C Clutch Disc And Hub From Compressor Shaft
      G04653832Courtesy of FORD MOTOR CO.
  4. Remove the pulley snap ring.
    Fig 3: Locating Pulley Snap Ring
    G04653833Courtesy of FORD MOTOR CO.
  5. Remove the A/C clutch pulley.
    1. Install the special tool.
    2. Remove the A/C clutch pulley.
      Fig 4: Removing A/C Compressor Pulley Using Special Tool
      G04653834Courtesy of FORD MOTOR CO.
    6. CAUTION: Do not use air tools. The A/C clutch field coil can be easily damaged.
  6. Remove the A/C clutch field coil.
    1. Install the special tool on the nose opening of the A/C compressor.
    2. Install the special tool.
    3. Remove the A/C clutch field coil.
      Fig 5: Identifying A/C Clutch Field Coil And Special Tool
      G04653835Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals