LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Parking Brake System & Actuation >> Removal And Installation >> Parking Brake Control >> Removal and Installation

Removal and Installation

  1. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  2. Release the parking brake.
  3. Disconnect the electrical connector.
    Fig 1: Locating Electrical Connector
    G04651654Courtesy of FORD MOTOR CO.
  4. Disconnect the parking brake cable from the parking brake control.
    • Remove the adjustment nut retaining clip.
    • Remove the adjustment nut.
  5. Remove the 2 parking brake control bolts and the parking brake control.
    • To install, tighten to 20 Nm (15 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals