- The fog lamps are inoperative
|
- Fuse
- Circuitry
- High beam relay
- Headlamp switch
|
|
- The individual fog lamp is inoperative
|
|
- MEASURE the resistance between the LH fog lamp C152-1 (early build) or C152-2 (late build), circuit 31-LD11 (BK), harness side and ground; or between the RH fog lamp C162-B (early build) or 162-2 (late build), circuit 31-LD17 (BK), harness side and ground.
- If the resistance is less than 5 ohms, REPAIR circuit 15S-LD11 (GN/WH) (LH fog lamp) or circuit 15S-LD17 (GN/WH) (RH fog lamp). TEST the system for normal operation.
- If the resistance is not less than 5 ohms, REPAIR circuit 31-LD11 (BK) (LH fog lamp) or circuit 31-LD17 (BK) (RH fog lamp). TEST the system for normal operation.
|
- The fog lamps are on continuously
|
- Circuitry
- Headlamp switch
|
- DISCONNECT the headlamp switch C205.
- If the fog lamps continue to illuminate, REPAIR the fog lamp voltage supply circuit. TEST the system for normal operation.
- If the fog lamps do not continue to illuminate, INSTALL a new headlamp switch. REFER to HEADLAMP SWITCH in this article. TEST the system for normal operation.
|