LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX4 ST >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake System >> Removal And Installation >> Rear Disc Brake >> Removal and Installation

Removal and Installation

  1. Release the parking brake.
  2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  3. Remove the parking brake cable from the brake caliper.
    1. Pull back the parking brake lever.
    2. Disconnect the cable from the parking brake lever.
    3. Remove the cable conduit retaining clip.
    4. Remove the cable from the brake caliper.
      Fig 1: Removing Park Brake Cable From Brake Caliper
      G04651646Courtesy of FORD MOTOR CO.
    4. CAUTION: Do not allow the brake caliper to hang from the hose or damage to the hose can occur.
  4. Remove the 2 brake caliper anchor plate bolts. Position the anchor plate and brake caliper aside as an assembly.
    • Support the assembly with mechanic's wire.
    • To install, tighten to 55 Nm (41 lb-ft).
  5. Remove the brake disc.
    • If equipped, remove the retaining clip.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals