LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX4 SES, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 829 (Electronic Engine Control System - 6.0L (99P E Series & 99P F450/550) Diesel Engine - F250-F550 Super Duty) >> Removal And Installation >> Engine Coolant Temperature (ECT) Sensor >> Installation

Engine Coolant Temperature (ECT) Sensor: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Apply clean engine oil to the new O-ring seal prior to installation.
  1. Using a new O-ring seal, install the ECT sensor.
    • Tighten to 18 Nm (13 lb-ft).
  2. Connect the ECT sensor electrical connector.
  3. Connect the cooling fan electrical connector.
    4. Fig 1: Locating Cooling Fan Electrical Connector
    GF0006052Courtesy of FORD MOTOR CO.
  4. Fill and bleed the engine cooling system. For additional information refer to ENGINE COOLING article.
scientia non olet · About LEMON Manuals