Selector Lever Knob: Removal

WARNING: This page is about a different variant/trim than selected.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Place the floor shift selector lever in the (D) position.

Fig 1: Locating Floor Shift Selector Lever In (D) Position
Gently pry up to remove the upper shift lever trim ring.

Fig 2: Identifying Upper Shift Lever Trim Ring
Remove the top finish panel.

Fig 3: Locating Top Finish Panel
Remove the set screw.

Fig 4: Locating Shift Knob Set Screw
Remove the knob and wiring by pulling straight up on the knob.

Fig 5: Pulling Knob And Wiring Straight Up On Knob
Remove and discard the shifter straw by pulling it straight up.

Fig 6: Locating Shifter Straw