LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Electronic Engine Control System - 3.0L (4V)) >> Removal And Installation >> Throttle Position (TP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the throttle position (TP) sensor electrical connector.
  3. Remove the 2 screws and the TP sensor.
    • To install, tighten to 3 Nm (27 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals