LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Electronic Engine Control System - 3.0L (4V)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the PCM and the 2 stud bolts.
    • Tighten to 9 Nm (80 lb-in).
  2. Connect the 3 PCM electrical connectors.
  3. Position the manifold absolute pressure sensor and the wiring harness and install the 2 PCM stud bolt nuts.
    • Tighten to 9 Nm (80 lb-in).
  4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION .
  5. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to ANTI-THEFT - PATS .
scientia non olet · About LEMON Manuals