LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Electronic Engine Control System - 3.0L (4V)) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the 5 bolts and the RH splash shield.
    • To install, tighten to 9 Nm (80 lb-in).
  4. Disconnect the crankshaft position (CKP) sensor electrical connector.
  5. Remove the bolt and the CKP.
    • To install, tighten to 10 Nm (89 lb-in).
    • Inspect the O-ring seal and install new as necessary.
    6. NOTE: Lubricate the CKP O-ring seal with clean engine oil.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals