LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Manual Transmission External Controls) >> Removal And Installation >> Gearshift Lever >> Installation

Gearshift Lever: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position the gearshift lever.
  2. Connect the select cable.
    Fig 1: Connecting Select Cable
    G04621102Courtesy of FORD MOTOR CO.
  3. Connect the gearshift cable.
    Fig 2: Connecting Gearshift Cable
    G04621103Courtesy of FORD MOTOR CO.
  4. Install the 2 gearshift cable clips.
    CAUTION: Make sure the clips are set completely within the cable adapter groove and fully seated.
    Fig 3: Locating Gearshift Cable Clips
    G04621104Courtesy of FORD MOTOR CO.
  5. Install the 4 gearshift lever bolts.
    • Tighten to 25 Nm (18 lb-ft).
  6. Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION .
  7. Install the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
scientia non olet · About LEMON Manuals