Chain Sprockets: Disassembly

WARNING: This page is about a different variant/trim than selected.

NOTE: Clamp the sprocket in a soft-jawed vise or damage to the sprocket can occur.

Fig 1: Removing No. 16 Reverse/Overdrive Ring Gear Bearing Using Special Tools

Courtesy of FORD MOTOR CO.

Using the special tools, remove the No. 16 reverse/overdrive ring gear bearing, as necessary.
Using the special tools, remove the No. 17 stator support bearing, as necessary.

Fig 2: Removing No. 17 Stator Support Bearing Using Special Tools
Courtesy of FORD MOTOR CO.