Torque Converter Clutch Operation Test

This test verifies that the torque converter clutch control system and the torque converter are operating correctly. Carry out the test as follows:

1. Carry out On-Board Diagnostic Test. Refer to INTRODUCTION - GASOLINE .
2. Connect a tachometer to the engine.
3. Bring engine to normal operating temperature by driving the vehicle at highway speeds for approximately 15 minutes in (D) position.
4. After normal operating temperatures are reached, maintain a constant vehicle speed of about 80 km/h (50 mph) and tap the brake pedal with the left foot.
5. Engine rpm should increase when the brake pedal is tapped, and should decrease about 5 seconds after the brake pedal is released. If this does not occur, see Torque Converter Operation Concerns. Refer to DIAGNOSIS BY SYMPTOM . If the vehicle is at a stop and stalls in (D) at idle, move the transaxle range selector lever to the manual 1 position, see Torque Converter Operation Concerns. Refer to DIAGNOSIS BY SYMPTOM . Repair as required. If the vehicle does not stall in manual 1, refer to DIAGNOSIS BY SYMPTOM .