Torque Converter Operation Concerns: No Apply

WARNING: This page is about a different variant/trim than selected.

TORQUE CONVERTER OPERATION CONCERNS: NO APPLY

Possible Component	Reference/Action
240 - ELECTRICAL ROUTINE
Powertrain Control System	-
Electrical inputs/outputs, vehicle wiring harnesses, powertrain control module, transmission fluid temperature (TFT) sensor, TCC solenoid, brake pedal position (BPP) switch, OSS, TSS	Carry out Torque Converter Operation Test. Refer to TORQUE CONVERTER DIAGNOSIS . Run On-Board Diagnostics Tests. Refer to INTRODUCTION - GASOLINE . GO to PINPOINT TEST B , GO to PINPOINT TEST C , and GO to PINPOINT TEST F .
340 - HYDRAULIC/MECHANICAL ROUTINE
Main Control	-
Bolts out of torque specification	Adjust bolts to specification.
Gasket damaged	Inspect for damage. Repair as necessary.
Solenoid pressure regulator valve, bypass clutch control valve and plunger, converter regulator valve stuck, damaged, misassembled	Inspect for damage. Repair as necessary.
TCC solenoid not functioning correctly	Activate solenoid using the Transmission Tester. Repair as necessary.
Hydraulic passages damaged	Inspect for damage. Repair as necessary.
Separator plates damaged or blocked	Inspect for damage. Repair as necessary.
Torque Converter Assembly	-
Leakage, internal damage	Inspect for damage and leakage. Carry out Torque Converter Operation Test. Refer to TORQUE CONVERTER DIAGNOSIS .