Shift Concerns: Some Or All Shifts Missing

WARNING: This page is about a different variant/trim than selected.

SHIFT CONCERNS: SOME OR ALL SHIFTS MISSING

Possible Component	Reference/Action
210 - ELECTRICAL ROUTINE
Powertrain Control System	-
-	Carry out Shift Point Road Test. Refer to SHIFT POINT ROAD TEST .
Electrical inputs/outputs, vehicle wiring harnesses, powertrain control module (PCM), shift solenoids, transmission range (TR) sensor, throttle position (TP) sensor, output shaft speed (OSS) sensor, TCS	Run On-Board Diagnostics Tests. Refer to INTRODUCTION - GASOLINE . GO to PINPOINT TEST A and GO to PINPOINT TEST D .
310 - HYDRAULIC/MECHANICAL ROUTINE
Fluid	-
Incorrect level	Fill to correct level.
Internal and External Shift Linkages	-
Damaged, out of adjustment, misassembled or internal linkage disconnected.	Inspect and repair as necessary. Verify linkage adjustment. Refer to AUTOMATIC TRANSAXLE-TRANSMISSION EXTERNAL CONTROLS - CD4E . After repairing linkage, verify that the transmission range (TR) sensor is correctly adjusted.
For diagnosis related to a specific gear use diagnostic tool to determine gear	Refer to the following shift routine(s) for further diagnosis:
Shift Concern: No 1-2 Shift	Routine 220/320
Shift Concern: No 2-3 Shift	Routine 221/321
Shift Concern: No 3-4 Shift	Routine 222/322