Other Concerns: No Engine Braking In Drive (TCS On) Or Manual 2ND Position

WARNING: This page is about a different variant/trim than selected.

OTHER CONCERNS: NO ENGINE BRAKING IN DRIVE (TCS ON) OR MANUAL 2ND POSITION

Possible Component	Reference/Action
259 - ELECTRICAL ROUTINE
Powertrain Control System	-
Electrical inputs/outputs, vehicle wiring harnesses, powertrain control module, 3-2 timing/coast clutch solenoid	Run On-Board Diagnostics Tests. Refer to INTRODUCTION - GASOLINE . GO to PINPOINT TEST G . Carry out Stall Speed Tests. Refer to SPECIAL TESTING PROCEDURES .
359 - HYDRAULIC/MECHANICAL ROUTINE
Internal or External Shift Linkages	-
Damaged, out of adjustment or misassembled	Inspect and repair as necessary. Verify linkage adjustment. Refer to AUTOMATIC TRANSAXLE-TRANSMISSION EXTERNAL CONTROLS - CD4E . After repairing linkage, verify that the transmission range (TR) sensor is correctly adjusted.
Pump Assembly	-
Pump support No. 2 or No. 3 seal rings for the coast clutch circuit damaged, missing	Inspect for damage. Repair as necessary.