LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine - 2.3L - (Except Hybrid)) >> In-Vehicle Repair >> Engine Oil Pressure (EOP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 5 bolts and the RH splash shield.
    • To install, tighten to 9 N.m (80 lb-in).
  3. Disconnect the oil pressure sender electrical connector.
  4. Remove the oil pressure sender.
    • To install, tighten to 15 N.m (11 lb-ft).
  5. To install, reverse the removal procedure.
    • Apply thread sealant to the oil pressure sender threads.
scientia non olet · About LEMON Manuals