LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Escape Hybrid, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine - 2.3L - (Except Hybrid)) >> In-Vehicle Repair >> Engine Mount >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the engine coolant degas bottle. For additional information, refer to REMOVAL AND INSTALLATION ALL VEHICLES .
  3. Install the special tool.
    Fig 1: Using Special Tool (303-F072) To Raise Engine
    G04618021Courtesy of FORD MOTOR CO.
  4. Remove the engine mount bracket bolt.
    • To install, tighten to 115 N.m (85 lb-ft).
  5. Use the special tool to raise the engine 25 mm (0.98 in).
    Fig 2: Using Special Tool (303-F072) To Raise Engine
    G04618022Courtesy of FORD MOTOR CO.
  6. Remove the 2 nuts and the engine mount bracket.
    • To install, tighten to 115 N.m (85 lb-ft).
  7. Remove the 3 bolts and the engine mount.
    • To install, tighten to 55 N.m (41 lb-ft).
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals